3300pF/3.33nF 50V 1206 ±5% C0G/NP0

KEMET’s Flexible Termination (FT-CAP) MLCC in C0G dielectric incorporates a unique, flexible termination system that is integrated with KEMET’s standard termination materials. A conductive silver epoxy is utilized between the base metal and nickel barrier layers of KEMET’s standard termination system in order to establish pliability while maintaining terminal strength, solderability and electrical performance. This technology was developed in order to address the primary failure mode of MLCCs– flex cracks, which are typically the result of excessive tensile and shear stresses produced during board flexure and thermal cycling. Flexible termination technology inhibits the transfer of board stress to the rigid ceramic body, therefore mitigating flex cracks which can result in low IR or short circuit failures. Capacitance change with reference to ambient temperature is limited to ±30 ppm/ºC from −55°C to +125°C.

AEC–Q200 automotive qualified
Up to 5 mm flex-bend capability
Operating temperature range from −55°C to +125°C
Capacitance offerings ranging from 0.5 pF up to 0.47 μF
DC voltage ratings of 10, 16, 25, 50, 100, 200 and 250V
No piezoelectric noise
Extremely low ESR and ESL
High thermal stability
High ripple current capability
Non-polar device, minimizing installation concerns